Owens Corning Home Energy Audit Nationwide

Owens Corning Home Energy Audit in Menlo Park: What to Know First

We provide independent Owens Corning home energy audit in Menlo Park, typically scheduled within 48 hours and completed in a single visit. Most audits run between $280 and $520 depending on home size and the scope of testing required, and we put that price in writing before anyone enters your home. This page is for Owens Corning product owners in Menlo Park who need a blower-door test, thermal imaging, or insulation inspection to diagnose why their conditioned air is leaving faster than it should. Call (510) 876-4113 to schedule or to get a free second opinion on another contractor’s written estimate.

Call (510) 876-4113

How Owens Corning Products Fail - and How We Fix Them

• AttiCat blown-in PINK Fiberglas settling below labeled R-value in Menlo Park’s marine climate. The steady fog-season moisture and temperature swings between Palo Alto Hills and the Bay side cause fiberglass to compact where attic ventilation is marginal. We measure settled depth with a ruled probe, calculate the degraded R-value, and recommend either top-up with new AttiCat or conversion to a higher-density material if the framing allows.
• FOAMULAR XPS rigid board tape failure at rim joists in crawl spaces. Owens Corning’s pink XPS performs well, but the acrylic tape specified for seams degrades in Menlo Park’s clay-heavy soils where seasonal moisture wicks through foundation walls. We find this with a thermal imager looking for cold stripes at the band joist, then remove the failed tape, reseal with compatible acrylic, and add mechanical fastening where the building code for San Mateo County requires it.
• QuietZone batts compressed by improper installation in 1950s ranch attics near Allied Arts Guild. These acoustic batts lose their noise-reduction value and half their thermal performance when stuffed into cavities smaller than the labeled width. We see this where original 2×4 ceiling joists were never meant to hold R-30. Our fix: remove the compressed batt, air-seal the top plates and electrical penetrations first, then install a properly sized product that fills without compression.
• ECOTOUCH batts with facing deterioration in vented attics with reverse airflow. The kraft facing delaminates when warm interior air pushes backward through the ceiling plane, a common pattern in Menlo Park homes with poorly balanced HVAC return paths. We identify this with a blower-door test - a pressurization reading that shows, in one number, how much air is moving the wrong direction - then seal the leaks before replacing any batts.
• ProPink LooseFill L77 uneven distribution from original installation shortcuts. The AttiCat machine settings and hose technique matter; we’ve found corners and eave edges starved for material while the center attic is overfilled. We map this with depth markers and thermal imaging, then redeploy material to achieve uniform coverage or add targeted air sealing at the eaves where wind washing is stripping heat.

Our Owens Corning Home Energy Audit Process

1. 1
   Schedule and written price. You call (510) 876-4113, a live person answers, and we deliver a written price by email before the appointment. No work starts without it - Haven Standard Clause 1.
2. 2
   Blower-door baseline test. We install a calibrated fan in an exterior door and depressurize the house to 50 Pascals. The CFM50 reading tells us exactly how leaky the envelope is before we open the attic hatch.
3. 3
   Thermal imaging and insulation inspection. Our tech walks the house with a FLIR camera while the blower door runs, mapping cold spots that indicate missing, settled, or moisture-compromised Owens Corning material. We photograph every finding.
4. 4
   Duct leakage test if indicated. When the thermal image shows supply registers blowing attic-temperature air, we pressurize the duct system and measure leakage to outside. This separates duct problems from envelope problems.
5. 5
   Written findings and prioritized scope. You get a printed report with the blower-door number, thermal images with temperature callouts, a photo record of what we found, and a flat price for any recommended work. We also note where OEM Owens Corning parts make sense versus where compatible alternatives perform equally.
6. 6
   Post-work verification. If you hire us for the repair, we run the blower door again and hand you the before-and-after ACH50 numbers. The 365-Day Done Right Promise covers everything in writing.

Before

After

What Owens Corning Home Energy Audit Costs in Menlo Park

Homes near the Menlo Park hills with conditioned crawl spaces or multiple attic planes typically land in the upper half of these ranges. We don’t charge extra for the photo record or the written report - both are included. Bring us a competing written estimate and we’ll review it with you at no cost. Call (510) 876-4113 for your exact price; estimates are free.

Why Menlo Park Homeowners Call Topside Attic Insulation Menlo Park for Owens Corning Work

We’ve sealed and insulated over 9,000 homes since 2016, and every one started with a written price and ended with a documented record. Wes Okafor, our owner, brought two decades of Midwest attic experience to the Peninsula and has run crews across Menlo Park for years - including a stretch of retrofits on older ranch-style homes near Allied Arts Guild where knob-and-tube wiring made air-sealing the first conversation, not the last. We source Owens Corning materials alongside Johns Manville, Knauf, Rockwool, and others, so we’re never locked into a single product line that doesn’t fit your house. Our technicians are background-checked and uniformed, and a live person answers calls 24/7. The 365-Day Done Right Promise means if it’s not done right, we make it right - backed by a written scope and warranty delivered before anyone lifts a tool.

FAQs